No products
Pagoda-2 Antenna Cover
New product
You have worked so hard to get your PCBs just right or enjoy the greatness of the Pagoda... Why not protect it?
STL's are available HERE
More info
You have worked so hard to get your PCBs just right or enjoy the greatness of the Pagoda... Why not protect it?
When installing the cover just put healthy amounts of CA around the edge of the PCB then slide the cover until its level with the top PCB, let the CA dry and never worry about breaking it again!
We have decided to discontinue the TPU covers because the benefit of the TPU with the higher dielectric was not great enough to use it over the ABS covers.
I am sharing the .STL for those that have access to a printer and materials. You can find it HERE
Reviews
what about printing with PLA or PETG?
Hi,
Did someone tested how PETG orr PLA might affect the gain?
Very nice to share the files
Very nice you're sharing the files directly.
Too bad shipping is so expensive to The Netherlands (11usd)
- 1 out of 1 people found this review useful.
Great covers
I am a TPU fan but i picked up a TPU and ABS since it said that there is a slight performance hit with TPU. Both arrived printed flawlessly and looked very nice. I slathered on some super glue and they are not going anywhere. Great addition to the Pagoda antennas.
Great covers
I am a TPU fan but i picked up a TPU and ABS since it said that there is a slight performance hit with TPU. Both arrived printed flawlessly and looked very nice. I slathered on some super glue and they are not going anywhere. Great addition to the Pagoda antennas.